Description
Product Overview
Part Number: PW482-50 Manufacturer: Yokogawa (Yokogawa Electric, Japan) Product Series: CENTUM VP DCS, FIO / N-IO Node Power Supply Module Type: DCS Node AC Power Supply Module PW482-50 is a dedicated AC input power supply module for Yokogawa CENTUM VP ANB10 / ANB11 FIO node units. It accepts 220~240VAC mains input and converts to stable internal regulated power to feed ESB bus coupler, I/O modules and backplane circuits inside the FIO node. Two PW482-50 modules can be installed in one node for dual-redundant power configuration to eliminate single-point power failure. Widely deployed in petrochemical, power generation, oil & gas and chemical process control systems. Supports hot-swap replacement during DCS online operation.
Technical Specifications
| Item | Parameter |
|---|---|
| Part Number | PW482-50 |
| Module Type | FIO Node AC Power Supply Module |
| Applicable System | Yokogawa CENTUM VP DCS, ANB10 / ANB11 FIO Node |
| Input | 220~240VAC, 50/60Hz |
| Max Input VA | 230VA |
| Output | Internal regulated power for node backplane & I/O modules, 120W rated power |
| Redundancy | Dual redundant hot backup supported |
| Hot Swap | Yes, online replacement |
| Protection | Overload, short-circuit, overvoltage protection |
| Operating Temperature | 0°C ~ +50°C |
| Storage Temperature | -20°C ~ +70°C |
| Humidity | 5~95% RH, non-condensing |
| Weight | Approx 1kg |
| Mounting | Rack mount inside FIO node unit |
Engineer Notes
- PW482-50 is 220~240VAC input version. Distinguish from PW481 (100-120VAC) and PW484 (24VDC). Must select correct model according to site incoming power.
- Dual redundant configuration: install two PW482-50 in the same FIO node. Automatic seamless switchover when one power module fails, no impact on control and I/O acquisition.
- Supports hot swap. Faulty PW482-50 can be pulled out and replaced while the DCS node remains online.
- Check front panel LED indicators for power status, fault alarm and redundancy health during commissioning and routine maintenance.
- Recommended service life for PW482 series power modules is 8 years; periodic preventive replacement is required for long-term plant operation.
- Proper grounding of the FIO node rack is required to reduce noise interference and improve power stability.
- Only used for CENTUM VP FIO/N-IO node; not compatible with legacy CS3000 DCS hardware.
Pre-Shipment Test Protocol
- Power-on test and power status LED verification
- Full load output stability test
- Redundancy switchover simulation test
- Overload and short-circuit protection functional test
- Internal circuit continuity & insulation inspection
- Visual inspection of housing, connectors, label and marking
- Anti-static & shockproof packaging inspection
Buyer FAQ
Q: Is PW482-50 new original? A: We supply brand new original Yokogawa units, 12-month warranty, factory test certificate available on request.
Q: What does suffix -50 mean? A: -50 stands for standard non-explosion-proof basic version of PW482 series.
Q: What is the difference between PW481, PW482 and PW484? A: PW481:100~120VAC input; PW482:220~240VAC input; PW484:24VDC input. They are interchangeable only when matched to site power source.
Q: Does PW482-50 support redundant power supply? A: Yes. Two PW482-50 modules can be installed in the same FIO node to realize dual redundant power supply.
Start Chat
Send an Email
